Konica

Code Description
F18 Paper lift did not complete
F23 Toner motor
F24 Pre clean lamp problem
F26 Toner density sensor
F34 Fuser overheat
F35 Fuser temperature too low. Lamp, thermofuse open wire
F36 Fuser temperature erratic. Probably thermistor
F41 End of scan sensor not actuated
F42 End of scan sensor not reached
F43 CVR (copy lamp voltage regulator)
F45 Lens or mirror movement problem
F52 Drive problem
F55 Zero cross.
F56 Waste toner collector box is full. After replacing it, you must enter code 94 in the 47 mode to reset
F60 ADF/machine interface problem
F67 ADF drive problem
F70 Sorter/machine interface problem
F77 Sorter bin problem
F78 Stapler problem
F86 Waste toner see 56
F98 Duplex problem
J11 Upper cassette
J12 Lower cassette
J13 Paper feed jam
J14 Paper feed jam
J15 Duplex unit jam
J16 Feed jam
J17 Feed jam
J19 Paper feed jam
J31 Exit jam
J32 Exit jam
J61 ADF opened during run
J62 ADF jam
J63 ADF jam
J65 RADF reverse jam
J72 Sorter jam, or sorter interlock opened
J75 Stapler jam
J92 Duplex stack gate sensor or other duplex problem
J93 Duplex stack gate sensor or other duplex problem
J94 Duplex stack gate sensor or other duplex problem
J95 Duplex motor or duplex jam
P17 Right door
P19 Right door of paper feed unit
P20 Drum not installed properly or toner level sensor connection problem
P33 Left door
P61 RADF reverse cover open
P64 ADF was selected at the wrong time
P71 Sorter interlock
P74 Stapler overloaded, or paper left in stapler bin
P76 Out of staples
P81 Key counter not installed
P82 Memory card problem
P96 Paper in stacker when duplex selected
P97 Used bypass in duplex mode
P99 More than one side than the other in duplex